Wire tracing

Wire tracing connects your poles. On the map, you mark what’s on each pole (crossarms, insulators, wires, equipment, guys) and then follow every wire from one pole to the next. The result is a connected model of the line: which wire is on which pin, at what height, and where it goes.

​

Why trace

• Ready for design. The traced model exports to SPIDAcalc with wires already connected pole to pole, so your engineers start designing instead of retyping attachments. See Export to SPIDAcalc.
• Mistakes show up early. Cloneable checks the trace as you go and flags crossed wires, wires traced twice, wires that stop short and labels that don’t add up, usually with a one-click fix.
• Heights come from photos. On calibrated photos, every pin gets its height as you place it, and midspan photos give each wire’s midspan height.

​

What you need first

• Measured pole photos. Fielders capture each pole with the Cloneable app. Calibrated measurement photos give attachment heights.
• Midspan photos for spans where you want midspan heights.
• Spans linking the poles, so Cloneable knows the order of the line.
• A configuration with a pick list, such as one built from your SPIDAcalc client file, so you pick real parts.
• Wire tracing switched on for your organization. Contact Cloneable support if you don’t see Trace wires in the map toolbar.

​

How it works

1. Open a pole or span on the map. A span opens both of its poles and the midspans between them.
2. Annotate a pole: mark its framing, insulators, wires and equipment on the photo.
3. Open the next pole, so both poles’ cards are open side by side.
4. Land each wire: tap the next pole’s photo where each wire attaches. On midspan photos, tap where each wire crosses.
5. Move on with Next segment and repeat down the line.

The guide in the bar at the bottom of the map tells you which of these steps you’re on. Your work saves automatically.

​

In this section